74LS04 Inverter (NOT Gate) on the Chart
A 74LS04 inverter (NOT gate) driven by a 0 to 5 V, 500 Hz square wave. The chart shows 1Y as the opposite of 1A: 3.97 V high while the input is low and…
Want to build your own circuit? Start a new circuit in the circuit simulator
Teaching with circuits?
Create a classroom, give your students a circuit to build, and review what they submit. Try it free with one classroom and up to 5 students.
Try the free classroom demoHow it works
What this circuit does
The 74LS04 holds six inverters (NOT gates). Each output is the opposite of its input: input low gives output high, input high gives output low. This circuit drives inverter 1 with a square wave and an LED shows the output.
How it is wired
Pins down the left side, then up the right side, as the lab draws them:
Pin 1, 1A: to the square-wave source (500 Hz).
Pin 2, 1Y: through a 1 kΩ resistor to the LED anode; the LED cathode goes to ground.
Pin 7, GND: to the ground part.
Pin 14, VCC: to the +5 V terminal.
The other five inverters are not used. The source is a ±2.5 V square wave standing on a 2.5 V terminal, so 1A swings between 0 V and 5 V.
What the chart shows
Switch the lab on and the chart draws the ticked boxes; you do not need to tick anything.
Ticked: 1A and 1Y. The chart covers 5 ms. 1A is low (0 V) from 0 to 1 ms, high (5.0 V) from 1 to 2 ms, and so on. 1Y does the opposite: 3.97 V while 1A is low and 0.13 V while 1A is high.
What's inside
- 2× Battery
- 1× Power Source
- 1× Resistor (1 kΩ)
- 1× LED
- 1× 74LS04