74LS00 NAND Gate Truth Table on the Chart
A 74LS00 NAND gate driven by two 0 to 5 V square waves (500 Hz and 1 kHz). The chart draws its truth table as a timing diagram: 1Y goes low only when both…
Преподавате с вериги?
Създайте клас, дайте на учениците си схема за сглобяване и прегледайте предадените работи. Опитайте безплатно с един клас и до 5 ученици.
Изпробвайте безплатната демо версия за класHow it works
What this circuit does
The 74LS00 holds four 2-input NAND gates. This circuit drives gate 1 with two square waves so that the chart shows every input combination one after another: a truth table drawn as a timing diagram. 1Y goes low only when both inputs are high.
The LED lights while 1Y is high.
How it is wired
Pins down the left side, then up the right side, as the lab draws them:
Pin 1, 1A: to square-wave source A (500 Hz).
Pin 2, 1B: to square-wave source B (1 kHz).
Pin 3, 1Y: through a 1 kΩ resistor to the LED anode; the LED cathode goes to ground.
Pin 7, GND: to the ground part.
Pin 14, VCC: to the +5 V terminal.
The other pins (gates 2 to 4) are not used. Each input source is a ±2.5 V square wave standing on a shared 2.5 V terminal, so each input swings between 0 V and 5 V.
What the chart shows
What's inside
- 2× Battery
- 2× Power Source
- 1× Resistor (1 kΩ)
- 1× LED
- 1× 74LS00