Lab

LM741 Non-Inverting Amplifier with a Gain of 3

An LM741 op-amp on a +12 V and -12 V supply amplifies a 1 V peak, 1 kHz sine. 20 kΩ and 10 kΩ set a gain of 3, so OUT swings between -3.0 V and +3.0 V in…

Preview of LM741 Non-Inverting Amplifier with a Gain of 3
Open in the lab Embed Run the circuit right here. To edit it in the full lab, sign in; free accounts have a time limit there.

Teaching with circuits?

Create a classroom, give your students a circuit to build, and review what they submit. Try it free with one classroom and up to 5 students.

Try the free classroom demo

How it works

What this circuit does

The LM741 is an operational amplifier. In the non-inverting amplifier the input goes to IN+ and two resistors feed part of the output back to IN-. The gain is 1 + Rf / Rg = 1 + 20 kΩ / 10 kΩ = 3, and the output is in step with the input.

How it is wired

Pins down the left side, then up the right side, as the lab draws them:

Pin 1, OFFSET1: not used.

Pin 2, IN-: to the point between Rf (20 kΩ, from OUT) and Rg (10 kΩ, to ground).

Pin 3, IN+: to the sine source (1 V peak, 1 kHz); the source's other side goes to ground.

Pin 4, V-: to the -12 V terminal.

Pin 5, OFFSET2: not used.

Pin 6, OUT: to Rf.

Pin 7, V+: to the +12 V terminal.

Pin 8, NC: not connected inside the chip.

What's inside

  • 2× Battery
  • 1× Power Source
  • 2× Resistor (20 kΩ, 10 kΩ)
  • 1× LM741

Tags

About

By Samir Sabri
Saved November 16, 2026
10 views
Page: dcaclab.com/circuits/88008-lm741-non-inverting-amplifier-with-a-gain-of-3

Embed this circuit

<iframe src="https://dcaclab.com/experiments/88008-lm741-non-inverting-amplifier-with-a-gain-of-3/iframe" width="560" height="410" frameborder="0"></iframe>

Cite: Sabri, S. (2026). LM741 Non-Inverting Amplifier with a Gain of 3. DCACLab. https://dcaclab.com/circuits/88008-lm741-non-inverting-amplifier-with-a-gain-of-3

Related circuits