Lab

LM358 Single-Supply Non-Inverting Amplifier

One half of an LM358 runs from a single 12 V supply with no negative rail. A sine of 1 V peak on a 2 V offset (1 V to 3 V) goes to IN1+, and two 10 kΩ…

Preview of LM358 Single-Supply Non-Inverting Amplifier
Open in the lab Embed Run the circuit right here. To edit it in the full lab, sign in; free accounts have a time limit there.

Teaching with circuits?

Create a classroom, give your students a circuit to build, and review what they submit. Try it free with one classroom and up to 5 students.

Try the free classroom demo

How it works

What this circuit does

The LM358 holds two op-amps that work from a single supply. This circuit uses amplifier 1 as a non-inverting amplifier with a gain of 1 + Rf / Rg = 1 + 10 kΩ / 10 kΩ = 2.

On a single supply the output cannot go below ground, so the input sine rides on a 2 V offset and stays between 1 V and 3 V.

How it is wired

Pins down the left side, then up the right side, as the lab draws them:

Pin 1, OUT1: to Rf (10 kΩ).

Pin 2, IN1-: to the point between Rf (from OUT1) and Rg (10 kΩ, to ground).

Pin 3, IN1+: to the sine source (1 V peak on a 2 V offset, 1 kHz); the source's other side goes to ground.

Pin 4, GND: to the ground part.

Pins 5 to 7, the second amplifier (IN2+, IN2-, OUT2): not used.

Pin 8, VCC: to the +12 V terminal.

What the chart shows

What's inside

  • 1× Battery
  • 1× Power Source
  • 2× Resistor (10 kΩ)
  • 1× LM358

Tags

About

By Samir Sabri
Saved November 16, 2026
7 views
Page: dcaclab.com/circuits/88006-lm358-single-supply-non-inverting-amplifier

Embed this circuit

<iframe src="https://dcaclab.com/experiments/88006-lm358-single-supply-non-inverting-amplifier/iframe" width="560" height="410" frameborder="0"></iframe>

Cite: Sabri, S. (2026). LM358 Single-Supply Non-Inverting Amplifier. DCACLab. https://dcaclab.com/circuits/88006-lm358-single-supply-non-inverting-amplifier

Related circuits