555 Timer Astable Oscillator Blinking an LED
A 555 timer in astable mode on 9 V: 1 kΩ, 10 kΩ and 10 µF make OUT switch between 7.8 V and 0 V about 6.8 times a second while THRSH charges and…
Want to build your own circuit? Start a new circuit in the circuit simulator
Teaching with circuits?
Create a classroom, give your students a circuit to build, and review what they submit. Try it free with one classroom and up to 5 students.
Try the free classroom demoHow it works
What this circuit does
The 555 is a timer. Wired as an astable oscillator it switches its output on and off by itself, forever. The timing capacitor charges through R1 and R2 and discharges through R2 into DISCH; each time it reaches 2/3 of the supply the output goes low, and each time it falls to 1/3 the output goes high again.
The output drives a red LED through 470 Ω, so the LED blinks.
How it is wired
Pins down the left side, then up the right side, as the lab draws them:
Pin 1, GND: to a ground part.
Pin 2, TRIGGER: to THRSH and the + side of the 10 µF capacitor.
Pin 3, OUT: through 470 Ω to the LED anode; the LED cathode goes to ground.
Pin 4, RESET: to a +9 V terminal (low would stop the timer).
Pin 5, CONT: not connected (a 10 nF capacitor to ground is common on a real board).
Pin 6, THRSH: to the capacitor + side; the capacitor - side goes to ground.
Pin 7, DISCH: to the point between R1 (1 kΩ, from +9 V) and R2 (10 kΩ, to THRSH).
What's inside
- 2× Battery
- 3× Resistor (1 kΩ, 10 kΩ, 470 Ω)
- 1× Capacitor
- 1× LED
- 1× 555 Timer