Makmal

Sawtooth Wave Generator using Diode and Opamp

An interactive diode, Op-Amp, resistor and capacitor circuit built in the DCACLab online simulator by Md. Anisur Rahman.

Preview of Sawtooth Wave Generator using Diode and Opamp
Open in the lab Embed The simulation runs as a demo that pauses after two minutes; open it in the lab to keep going.

Teaching with circuits?

Create a classroom, give your students a circuit to build, and review what they submit.

See classroom plans

What's inside

  • 4× Resistor (5 kΩ, 40 kΩ, 100 kΩ)
  • 1× Capacitor
  • 2× Diode
  • 2× Op-Amp
  • Measured with Oscilloscope

Tags

Capacitor Diode Oscilloscope Op-Amp Resistor

About

By Md. Anisur Rahman
Saved June 15, 2021 · updated September 05, 2026
5,492 views
Page: dcaclab.com/circuits/37134-sawtooth-wave-generator-using-diode-and-opamp

Embed this circuit

<iframe src="https://dcaclab.com/experiments/37134-sawtooth-wave-generator-using-diode-and-opamp/iframe" width="560" height="410" frameborder="0"></iframe>

Cite: Rahman, M. (2021). Sawtooth Wave Generator using Diode and Opamp. DCACLab. https://dcaclab.com/circuits/37134-sawtooth-wave-generator-using-diode-and-opamp

Related circuits