Laboratório

Clipping of Both Half Cycles

Clipping of Both Half Cycles If we connected two diodes in inverse parallel as shown, then both the positive and negative half cycles would be clipped as…

Preview of Clipping of Both Half Cycles
Open in the lab Embed The simulation runs as a demo that pauses after two minutes; open it in the lab to keep going.

Teaching with circuits?

Create a classroom, give your students a circuit to build, and review what they submit.

See classroom plans

How it works

Clipping of Both Half Cycles

If we connected two diodes in inverse parallel as shown, then both the positive and negative half cycles would be clipped as diode D1 clips the positive half cycle of the sinusoidal input waveform while diode D2 clips the negative half cycle. Then diode clipping circuits can be used to clip the positive half cycle, the negative half cycle or both.

Reverse and Forward diode = DIAC

What's inside

  • 1× Power Source
  • 1× Resistor (993 mΩ)
  • 2× Diode
  • Measured with Oscilloscope

Tags

Diode Power Source Oscilloscope Resistor

About

By Md. Anisur Rahman
Saved February 07, 2020 · updated September 05, 2026
17,555 views
Page: dcaclab.com/circuits/16637-clipping-of-both-half-cycles

Embed this circuit

<iframe src="https://dcaclab.com/experiments/16637-clipping-of-both-half-cycles/iframe" width="560" height="410" frameborder="0"></iframe>

Cite: Rahman, M. (2020). Clipping of Both Half Cycles. DCACLab. https://dcaclab.com/circuits/16637-clipping-of-both-half-cycles

Related circuits