Build breadboard circuits on a virtual breadboard with 63 numbered columns and rows a to j. The breadboard is the background of the board, so parts and jumper wires go straight into its holes, and the circuit runs as you build it.
How breadboard connections work
- Each column has two groups of five holes: holes a to e are connected, and so are holes f to j.
- The centre gap separates the two halves. On a real board, chips sit across the gap so each pin gets its own column.
- Four power rails run along the top and the bottom, a + and a − at each edge. Each rail is connected along its length, and the rails are not connected to each other.
Build your first breadboard circuit
- Pick a battery, a resistor and an LED from the components panel: click a part, or drag it onto the breadboard.
- Put legs that should be connected in the same column (a to e, or f to j), and a part's two legs in different columns.
- Draw a jumper wire by dragging from a part's leg to where it should connect, for example from the battery to a power rail.
- The circuit runs as you build. Add the multimeter or the oscilloscope from the components panel to measure voltage and current.
Want to wire a circuit without the breadboard? Open the
circuit simulator.
To draw the schematic, use the
circuit diagram maker.